Fcdft option – RLE LD5000 User Manual
Page 28
Chapter 7: LCD Setup Menu
User Guide: LD5000
20 970.484.6510
www.rletech.com
7-6
FCDFT
OPTION
The FCDFT option will allow the user to restore the LD5000 to factory calibration default settings.
Cable Auto Calibrate:
Step 4 of 4
Cable Auto Cal Done
Saving Changes. .
Cable Auto Calibrate
:
Step 3 of 4
****** LD5000 ******
* RLE Technologies *
** Copyright 2000 **
************************
Erasing Data . .
Writing Data . .
Done, Press any key
to continue
Restore Factory
Defaults?
->Accept Cancel
See also other documents in the category RLE Equipment:
- LD2000 Quick Start (2 pages)
- LD300 (2 pages)
- LDZ4 (19 pages)
- LD2000 (78 pages)
- LD5100 Quick Start (2 pages)
- LD310 (2 pages)
- LD5000 Quick Start (4 pages)
- LD1000 (2 pages)
- LD5100 (72 pages)
- 10K Quick Start (2 pages)
- F200 (2 pages)
- LDRA6 Quick Start (2 pages)
- 10K V.2.5.a (44 pages)
- LD1500 Quick Start (2 pages)
- LD2100 Quick Start (2 pages)
- LD5200 Quick Start (2 pages)
- LD1500 V.3.1 (52 pages)
- FDS-Wi Quick Start (2 pages)
- GD100 (26 pages)
- FDS-Wi V.2.5 (74 pages)
- LD2100 V.2.6 (92 pages)
- LD5200 V.2.3 (118 pages)
- F-Series Quick Start (2 pages)
- F110 Quick Start (2 pages)
- Wi-MGR Quick Start (2 pages)
- Wi-MGR V.1.6 (74 pages)
- FMS Quick Start (2 pages)
- FMS32 (92 pages)
- Ground Fault Monitor (2 pages)
- RA1x2 (2 pages)
- Protocol Converter Quick Start (2 pages)
- Protocol Converter V.2.4 (70 pages)
- Falcon EM (146 pages)
- FMS V.1.13 (226 pages)