REMKO Multi-talent - Manual (Page 40)

REMKO HEAT PUMP MANAGER
Designation Value range Factory setting Description
Operation HCP
Standard
Heating limits
only time prog
Continuous
operation
Standard
Setting the operating mode for the heating circuit pumps.
The pumps are shut off if there is no heating requirement.
At the same time the mixer of the heating circuit closes.
• Standard
- with weather-controlled target temperature regulation
through heating curve:
Pump OFF if the current outside temperature
[Sensor 09] has become warmer than the set temperature
and by the activation of the operating mode
T-room target temperature.
- with room-guided regulation (only active in combination
with a remote control)
Pump OFF if the current room temperature has become
more than 1K warmer than the set room target
temperature.
• Heating limits
The pump is switched analogously to the set heating
limits (see User Heating circuit 1/2
Heat limit day/Heat limit night)
• Only time programme
Pump is switched according to the heating programme
(see User Time programme Heat circuit 1Prog
1/2 and/or Heat circuit 2 Prog 1/2
• Continuous operation.
The pump runs continuously for 24h.
Mixer Open 5,0-25,0 7,0
Setting the speed with which the mixer opens in the event
of a control deviation (mixer dynamic opening).
The control deviation is entered in Kelvin where the mixer
opens without interruption.
Small values lead to fast operation of the mixer and can lead
to vibrations.
Mixer Closed 5,0-25,0 7,0
Setting the speed with which the mixer closes in the event of
a control deviation (mixer dynamic closing).
The control deviation is entered in Kelvin where the mixer
closes without interruption.
Small values lead to fast operation of the mixer and can lead
to vibrations.
Max T-supply 10.0°C-110.0°C 55.0°C
Setting the maximum supply temperature for the selected
heating circuit.
The calculated supply target temperature for the heating
circuit is limited by the set maximum supply temperature
(overheating protection).
The heating circuit pump for the direct heating circuit is only
switched off if the [sensor 08] exceeds the temperature set
here by 8K.
The heating circuit pump switches on again if the
temperature [sensor 08] falls below the temperature
(Max T-supply+5K).
Heating circuit 1/2-continued
Level 4 - SPECIALIST - Description of parameters and settings - continued
40