NewTek 3Play 820 - Manual (Page 54)

Page | 40
By now, you should see live video from the configured connections on the input monitors.
4.3 OUTPUT AND CONTROL MODES
7. Press A on the control surface to designate the Output Mode
8. Press LIVE to set the Control Mode – see sections 8.4 and 8.5 for explanations of these
modes.
9. Push the P3 button to send the live source from input 3 to the current output (A).
10. Push B on the control surface to update the current Output Mode.
11. Press LIVE again, to set the Control Mode for output B – note that outputs have
independent Control Modes.
12. Push the P2 button to send the live source from input 1 to the current output (B).
4.4 RECORD AND SPEED
13. Watching Output B, push the Stop button on the control surface.
14. Push the 25% Speed preset button, then press Play, still watching Output B.
Well, that was unimpressive. Playback ignored our control surface operations, and continued at
full normal speed. Why? This is because we have not yet enabled recording. Stopping or
changing the Speed of a LIVE source would automatically kick playback into Delayed mode - if it
could. However, this requires 3Play™ to be recording.
Let’s try that again, enabling recording first. Remember that Speed (for Output B) is still set to
25% (if you checked, Output A would still be at the default speed, 100%)
15. Press the red REC (Record) button on the control surface, to enable capture.