Gasboy Enhanced Communications - Manual (Page 22)

Site Preparation, Setup Programming, and Testing
Page 22 MDE-4520C Enhanced Communications Installation Manual · February 2008
8 After the PC reboots, connect the appropriate RS-232 cable between the computer COM port
and the wireless modem. See
Appendix: Cable Information on page 51 for cable details.
9 Connect DC power to the modem.
Programming the Wireless Modems
To program the wireless modems, proceed as follows:
1 Click the Radio Programmer icon on your desktop. The Coyote DataCom Radio
Programmer window appears.
Figure 13: Default Coyote DataCom Radio Programmer Window
Source Group
Destination Group
Destination
Address
Source Address
Tx Holdoff Time
Packet Size
CTS De-Assert
CTS Assert
Baud Rate
Write
Read
No AckBack
Wait for AckBack
Preamble Bytes
Note: If you get an error message regarding the COM port, click Utilities > Port Setting and
select the correct port through which you are communicating. The Default setting is
COM 1.
2 Click Read to get Config information from the Modem.
3 Locate the Source Group and Destination Group on the Screen, and set the values to one (1)
for all modems.