Gasboy Enhanced Communications - Manual (Page 2)

Introduction
Page 2 MDE-4520C Enhanced Communications Installation Manual · February 2008
• The Wireless solution cannot extend communications between Gasboy devices [such as Island
Card Readers (ICR), 9800 series pumps, Gasboy Pump Control Units (PCU)], and other
manufacturer electronic pumps. Also, it is not intended to be used for credit card network
communications.
• The Wireless solution is only intended for point-to-point communication between one PC and
one Gasboy Fuel Management System (FMS) at a time. Multiple Gasboy FMS systems will
require one Base Station kit and one Fueling Position kit for each point-to-point wireless
communication link. An RS-232 A/B has to be locally supplied to switch between the multiple
base stations and Gasboy FMS systems.
IMPORTANT INFORMATION
Table of Contents
Topic Page
Introduction 1
Important Safety Information 7
Parts Information 9
Site Installation Review and Considerations 13
Site Preparation, Setup Programming, and Testing 20
HyperTerminal Test 25
Serial-to-LAN Connection Installation 28
Appendix: Cable Information 51
Required Tools
The following tools are required for the installation of the kit:
• Phillips ® Screwdriver
• Soldering Iron and Solder
• Wire Strippers
• Needle Nose Pliers
• Diagonal Cutters
• 3/8 inch Socket Wrench Kit
Parts List
Fueling Position Wireless Communication Kit (M06544K001)
Description Part Number Quantity
Assembly, Radio Housing M06545A001 1
Bracket, Pedestal to Pole M05844B001 2
Base, Modified TopKAT M05845B001 1
Conduit Fitting M01756A001 1
Tube Flex Conduit Non M01575B003 1
Cable, RS-232/Power To M06543A001 1
Antenna, 8.5 DBD 6 Element M06554A001 1
Cable, Antenna 25 FT Coax M06549A001 1
Sware, Coyote Datacom KS319-001PC 1