Gasboy Enhanced Communications - Manual (Page 21)

MDE-4520C Enhanced Communications Installation Manual · February 2008 Page 21
Site Preparation, Setup Programming, and Testing
3 Pull the braid wires forward and taper them towards the center conductor. Place the clamp over
the braid and push it back against the cable jacket.
4 Fold back the braid wires as shown, trim the braid to proper length and form over the clamp as
shown. Tin center conductor and solder on contact.
5 Insert the cable and parts into the connector body. Ensure that the sharp edge of the clamp
seats properly in the gasket. Tighten the nut.
Installing the CDR Tools Software for the Wireless Modem Setup
The CDR Tools Software from Coyote must be used to program the Coyote wireless modem.
This KS319 001PC software is provided with the Base Station kit.
You should load this software on your computer and the Site PC that will be connected to the
wireless modem. When the installation is complete, the Radio Programmer icon appears on
your desktop.
To install the CDR Tools Software, proceed as follows:
1 Insert the diskette into the appropriate drive.
2 Click Start > Run. The Run dialog box appears.
3 Type A:\Setup.
Note: On most computers, the floppy drive is referred to as “A”. If your floppy drive is not
referred to as “A”, type the appropriate letter. The installation process begins.
4 At the License Agreement screen, click Yes.
5 At the Setup Type screen, select Typical and click Next. The copying of files begins.
6 Insert Disk 2 when instructed to do so, and click OK.
7 Click Yes to restart your computer.