Parts not supplied by gasboy, Important information caution, Caution – Gasboy Enhanced Communications User Manual
Page 12: Additional parts supplied at the gasboy system end, Additional parts supplied at the pc end
Parts Information
Page 12
MDE-4520C Enhanced Communications Installation Manual · February 2008
Additional Parts Supplied at the Gasboy System End
Parts
Explanation
Gasboy TopKAT Riser Collar
(M05845B001)
Under the Gasboy TopKAT on a pedestal, a field-installed
Riser Collar is placed. This collar has one flexible conduit
outlet that is attached directly to the wireless modem
enclosure. In addition, it has the clamp assemblies that
attach the Gasboy TopKAT to one leg of the antenna tower
or mast, and facilitates mounting of the wireless modem
enclosure. This conduit will allow DC power and RS-232
communications between the Gasboy TopKAT and the
wireless modem.
• The RS-232 wiring for the individual Gasboy systems is
.
• The DC power wire provided will work with any system.
It may be cut to length, if needed.
Do not use this riser collar for any other Gasboy system. It is only to be used on
pedestal mounted TopKATs. For all other Gasboy systems including TopKATs mounted
on a dispenser, refer to
.
IMPORTANT INFORMATION
CAUTION
The Gasboy pedestal mount TopKAT should be completely removed to install the
collar. Ensure that you fully understand how to replace all disconnected cables, so
that they can be properly reinstalled once the collar is installed, and properly
attached. Failure to do so can cause damage to the system, and is not covered by
the warranty.
CAUTION
Additional Parts Supplied at the PC End
Parts
Explanation
RS-232 Communication cable (Q13850-15)
See
on
for proper
cable connection.
This is a 15-foot CAT-5 Cable with gender menders at each
end to interface the PC to the Modem Interface Board.
Parts Not Supplied by Gasboy
Parts
Explanation
Towers, Masts, and Mast
Mounting Brackets
• The distributor is responsible for supplying, and properly installing the towers,
masts, or mast mounting brackets.
• The manufacturer's installation manual MUST be followed.
Towers or masts at the
Gasboy system end
• Up to a 28-foot tower can be installed at the Gasboy system end without the use of
guy wires. This can consist of a 10-foot tower and a 10-foot mast for a total of 18
feet, or a 20-foot tower and a 10-foot mast for a total of 28 feet.
• The height of the tower is to be determined by the line of sight requirements of the
antenna located on the top of this tower or mast, to the PC wireless modem and its
antenna at the top of its mast or tower.
• An appropriate base plate/mounting bracket to support the tower may be sourced
from one of the following:
– Tally Communication (