Comtech EF Data DT-4500-A Series - Manual (Page 76)

DT-4500-A Series Downconverters Revision 1
Front Panel Operation MN-DT4500A
5–8
You may view or edit the SNMP Write Community string. To edit, first use the ◄
► arrow keys to select the character to edit, and then use the ▲ ▼ arrow keys
to edit that character. Press ENTER when done.
CONFIG: Remote Control  ETHERNET  SNMP 
COMMUNITIES TRAP
Trap Community:
comtech
You may view or edit the SNMP Trap Community string. To edit, first use the ◄
► arrow keys to select the character to edit, and then use the ▲ ▼ arrow keys
to edit that character. Press ENTER when done.
CONFIG: Remote Control  ETHERNET  SNMP  TRAPS
TRAPIP1 TRAPIP2 VERSION
IP1 IP2 Version
Use the ◄ ► arrow keys to select TRAPIP1, TRAPIP2, or VERSION, and then press
ENTER.
CONFIG: Remote Control  ETHERNET  SNMP  TRAPS 
TRAPIP1/TRAPIP2
TRAP IP ADDRESS #1:
000.000.000.000
TRAP IP ADDRESS #2:
000.000.000.000
You may view or edit the Trap Destination’s IP Addresses. To edit, first use the ◄
► arrow keys to select the digit to edit, and then use the ▲ ▼ arrow keys to edit
the value of that digit. Press ENTER when done.
Note: If both Trap IP Addresses are 000.000.000.000, it means Traps are disabled.
CONFIG: Remote Control  ETHERNET  SNMP  TRAPS 
VERSION
Trap Version:
SNMPv1 SNMPv2
Use the ▲ ▼ arrow keys to select the trap version – SNMPv1 or SNMPv2 – and
then press ENTER.