Comtech EF Data DT-4500-A Series - Manual (Page 60)

DT-4500-A Series Downconverters Revision 1
Rear Panel Connectors MN-DT4500A
3–10
3.3.1 Cable Connections – Standalone (Non-Redundant) Operation
In standalone (non-redundant) downconverter configurations, the downconverter has an
Input/Output Module (IOM-XX) for the RF Input and the IF Output. A downconverter with a
Transmit Switch Module (TSM-XX) or Receive Switch Module (RSM-XX) may be operated in a
non-redundant configuration if an IOM is unavailable.
Figure 3-4 shows a non-redundant configuration using with an IOM installed; Figure 3-5 shows
cabling accomplished with an RSM installed.
Figure 3-4. Standalone (Non-Redundant) Downconverter Configuration with
Input/Putput Module (IOM-XX)
Figure 3-5. Standalone (Non-Redundant) Downconverter Configuration with Receive Switch
Module (RSM-XX)