Comtech EF Data DT-4500-A Series - Manual (Page 119)

DT-4500-A Series Downconverters Revision 1
Appendix A MN-DT4500A
A–9
A.7.1.7 IP Address
Use the IPA command to set the IP address and network prefix for the 100BASE-TX Ethernet
management port. The factory default value is 192.168.1.4.24.
Command Details
Set IP Address:
Where:
aaa = 0-223
bbb = 0-255
ccc = 0-255
ddd = 0-255, but they cannot all be zero.
yy is the Subnet Mask Length (range: 8 to 30)
Confirmation: >DEV/IPA_ aaa.bbb.ccc.ddd.yy'cr'lf']
Retrieve IP Address: _'cr'
Confirmation: >DEV/IPA_ aaa.bbb.ccc.ddd.yy'cr''lf']
A.7.1.8 IP Gateway
Use the IPG command to set the IP gateway address for the Ethernet management port. The
factory default value is 192.168.1.5.
Command Details
Set IP Gateway:
Where:
aaa = 0-223
bbb = 0-255
ccc = 0-255
ddd = 0-255, but they cannot all be zero.
Confirmation: >DEV/IPG_ aaa.bbb.ccc.ddd'cr'lf']
Retrieve IP Gateway: _'cr'
Confirmation: >DEV/IPG_ aaa.bbb.ccc.ddd'cr''lf']
A.7.1.9 Physical Address
The default physical address is 001.
Command Details
Set Physical Address:
Confirmation: >DEV/SPA_xxx'cr''lf']
Retrieve Phys. Addr:
Confirmation: >DEV/SPA_xxx'cr''lf']