Comtech EF Data SNM-1002 - Manual (Page 88)

SNM-1002 LinkSync
 Modem
Revision 2
Operation MN/SNM1002.OM
3–48
EXT AGC: MIN PWR
10.0 VOLTS
Sets the AGC voltage for a receive signal level of -25.0 dBm. The voltage range is 0.0 to
10.0V, in 0.5V steps.
Upon entry, the current external AGC voltage level is displayed. Press [
↑] or [↓] to
increment or decrement the AGC voltage level in 0.5V steps. Press [ENTER] to execute the
change.
Note: For any receive signal level between -25.0 and -60.0 dBm, the software will
interpolate the required AGC voltage.
3.4.5.4.17 SYSTEM:MASTER RESET
MASTER RESET
HARD/SOFT
CAUTION
Initiating a hard reset will reset the modem and place the
default configuration settings in ROM. Initiating a soft reset
will reset the modem hardware, but saves the current
configuration settings
.
Select [ENTER] once to access HARD or SOFT.
Press [
←] or [→] to make the selection. Press [ENTER].
Press [
→] five times to move the cursor to YES. Select YES and press [ENTER] again.
Note: The following parameters do not revert to default settings after a hard reset:
• Address
• Parity
• Baud Rate
• Remote Type
• Ext AGC: Min Pwr
• Ext AGC: Max Pwr
• Display Contrast
3.4.5.5 UTILITY:MODEM TYPE