Comtech EF Data SNM-1002 - Manual (Page 135)

SNM-1002 LinkSync
 Modem
Revision 2
Remote Control Operation MN/SNM1002.OM
A–9
Baseband
Loopback Command:
Response:
Status:
Response: >add/BBL_xxx'cr''lf']
>add/BBL_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface
Loopback Command:
Response:
Status:
Response: >add/ILB_xxx'cr''lf']
>add/ILB_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface
Loop
Timing Command:
Response:
Status:
Response: >add/ILT_xxx'cr''lf']
>add/ILT_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface
Buffer Size Buffer size programming is supported in two formats; bits, or milli-seconds. The selected format must be
chosen using the buffer programming command (IBP_). If the buffer is to be programmed in milli-seconds
and plesiochronous slips are required use the receive framing structure command (IRFS_) to define the
proper framing format.
Note: For Drop & Insert: Only milli-seconds format is allowed.
Interface
Buffer Size
(Bit
Format) Command:
Response:
Status:
Response: >add/IBS_nnnnnn'cr''lf']
>add/IBS_nnnnnn'cr''lf']
Where: nnnnnn = 32 to 262144, in 16 bit
increments.
Interface
Buffer Size
(Milli-
second
Format) Command:
Response:
Status:
Response: >add/IBS_nn'cr''lf']
>add/IBS_nn'cr''lf']
Where: nn = 0 to 99 (buffer size in milli-seconds).
Note: For Drop & Insert:
1. nn = 7.5, 15, or 30 (milli-seconds) for
E1CAS format.
2. nn = 6, 12, 24, or 30 (milli-seconds)
for T1S/T1ESFS format.
3. nn = 1, 2, 4, 8, 16, or 32 (milli-
seconds) for all other D&I formats.
Interface
Buffer
Center Command:
Response:
>add/IBC_'cr''lf']
Interface
Buffer
Program-
ming Command:
Response:
Status:
Response: >add/IBP_xxxx'cr''lf']
>add/IBP_xxxx'cr''lf']
Where: xxxx = BITS or MS (milli-seconds).
Note: For Drop & Insert: Only milli-seconds format
is allowed.
Interface
Receive
Farming
Structure Command:
Response:
Status:
Response: >add/IRFS_ff_ssss'cr''lf']
>add/IRFS_ff_ssss'cr''lf']
Where:
ff = T1 or E1 (frame type).
ssss = NONE or G704 (framing structure).