Comtech EF Data SNM-1002 - Manual (Page 150)

SNM-1002 LinkSync
 Modem
Revision 2
Remote Control Operation MN/SNM1002.OM
A–24
Receive
Signal
Level
Status Command:
Response:
>add/RSL_xsnn.ndBm'cr''lf']
Where:
x = < or > (data modifier to indicate that the
receive signal level is less than or greater than
the returned value).
s = + or - (receive signal level sign, plus or
minus).
nn.n = 0.0 to 99.9 (receive signal level
magnitude).
Notes:
1.
The 'x' (< or >) parameter is only
returned if the level has exceeded the
computational resolution of the system.
2.
'No Data' is returned if the level cannot
be calculated.
3.
Sampling' is returned if not enough data
is currently available to calculate the level.
Interface
Buffer Fill
Status Command:
Response:
>add/IBFS_nn%'cr''lf']
Where: nn = 1 to 99 (relative to buffer depth).
Current
Sweep
Value Command:
Response:
>add/CSV_xsnnnnn'cr''lf]
Where:
x = < or > (data modifier to indicate that the
sweep offset value is less than or greater than
the returned value).
s = + or - (sweep offset from center).
nnnnn = 0 to 35000.
yyy = OK or FLT (decoder lock status OK or
FAULT).
Notes:
1.
The 'x' (< or >) parameter is only
returned if the level has exceeded the
computational resolution of the system.
2.
'No Data' is returned if the level cannot
be calculated.
3.
'Sampling' is returned if not enough data
is currently available to calculate the level.