Comtech EF Data SNM-1002 - Manual (Page 134)

SNM-1002 LinkSync
 Modem
Revision 2
Remote Control Operation MN/SNM1002.OM
A–8
A.3.3 Interface
Interface
Transmit
Overhead
Type Command:
Response:
Status:
Response: >add/ITOT_xxxxx'cr''lf']
>add/ITOT_xxxxx'cr''lf']
Where: xxxxx = NONE
Interface
Receive
Overhead
Type Command:
Response:
Status:
Response: >add/IROT_xxxxx'cr''lf']
>add/IROT_xxxxx'cr''lf']
Where: xxxxx = NONE
TX Driver
Type Command:
Response:
Status:
Response: >add/TXDR_xxxxx'cr''lf']
>add/TXDR_xxxxx'cr''lf']
Where: xxxxx = V35, RS422, or RS232.
RX Driver
Type Command:
Response:
Status:
Response: >add/RXDR_xxxxx'cr''lf']
>add/RXDR_xxxxx'cr''lf']
Where: xxxxx = V35, RS422, or RS232.
Transmit
Clock Command:
Response:
Status:
Response: >add/TC_xxx'cr''lf']
>add/TC_xxx'cr''lf']
Where: xxx = INT (internal SCT clock), EXT
(external TX terrestrial clock), REF (external clock-
reference frequency).
External
Clock-
Reference
Frequency
Command:
Response:
Status:
Response: >add/ERF_nnnnn.n'cr''lf']
>add/ERF_nnnnn.n'cr''lf']
Where: nnnnn.n = 8.0 to 10000.0 (external clock
frequency in kHz).
Transmit
Clock
Phase Command:
Response:
Status:
Response: >add/TCP_xxxx'cr''lf']
>add/TCP_xxxx'cr''lf']
Where: xxxx = NRM (normal clock phasing), INV
(inverted clock phasing), AUTO (automatic clock
phasing).
Buffer
Clock Command:
Response:
Status:
Response: >add/BC_xxx'cr''lf']
>add/BC_xxx'cr''lf']
Where: xxx = INT (internal SCT clock), EXT
(external TX terrestrial clock), SAT (receive satellite
clock), REF (external clock-reference frequency),
INS (insert clock).
Receive
Clock
Phase Command:
Response:
Status:
Response: >add/RCP_xxx'cr''lf']
>add/RCP_xxx'cr''lf']
Where: xxx = NRM (normal clock phasing), INV
(inverted clock phasing).