Comtech EF Data SNM-1002 - Manual (Page 155)

SNM-1002 LinkSync
 Modem
Revision 2
Remote Control Operation MN/SNM1002.OM
A–29
Bulk Consol.
Status
(continued)
Parameter
Number Parameter Name
(Command Reference)
Description
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
Demodulator rate
(ref. 'DR_' command).
Demodulator preset A
(ref. 'ADRA_' command).
Demodulator preset B assignment
(ref. 'ADRB_' command).
Demodulator preset C assignment
(ref. 'ADRC_' command).
Demodulator preset D assignment
(ref. 'ADRD_' command).
Demodulator preset V assignment
(ref. 'ADRV_' command).
Descrambler enable
(ref. 'DE_' command).
Differential decoder
(ref. 'DDEC_' command).
RF loopback
(ref. 'RFL_' command).
IF loopback
(ref. 'IFL_' command).
Sweep center frequency
(ref. 'SCF_' command).
Sweep width range
(ref. 'SWR_' command).
Sweep reacquisition
(ref. 'SR_' command).
BER threshold
(ref. 'BERT_' command).
Demodulator type
(ref. 'DT_' command).
Demodulator decoder type
(ref. 'DDT_' command).
Transmit clock source
(ref. 'TC_' command).
External reference frequency
(ref. 'ERF_' command).
p17 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p18 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p19 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p20 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p21 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p22 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p23 = n, where 'n' is '0' (off) or '1' (on).
p24 = n, where 'n' is '0' (off) or '1' (on).
p25 = n, where 'n' is '0' (off) or '1' (on).
p26 = n, where 'n' is '0' (off) or '1' (on).
p27 = snnnnn, sweep center frequency in Hertz.
p28 = nnnnn, sweep range in Hertz.
p29 = nnn, reacquisition time in seconds.
p30 = xxxx, BER threshold.
p31 = n, where 'n' is '0' (EFD), '1' (INTL), '3' (FDC), or '4'
(CSC).
p32 = n, where 'n' is '0' (SEQ), '1' (VIT).
p33 = n, where 'n' is '0' (INT), '1' (REF), '2' (EXT), or 6
(DATA).
p34 = nnnnn.n, external reference frequency in kHz.