Comtech EF Data SNM-1002 - Manual (Page 154)

SNM-1002 LinkSync
 Modem
Revision 2
Remote Control Operation MN/SNM1002.OM
A–28
Parameter
Number Parameter Name
(Command Reference)
Description
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Modulator RF output
(ref. 'RF_' command).
Modulator IF frequency
(ref. 'MF_' command).
Modulator rate
(ref. 'MR_' command).
Modulator preset 'A' assignment
(ref. 'ARMA_' command).
Modulator preset 'B' assignment
(ref. 'ARMB_' command).
Modulator preset 'C' assignment
(ref. 'ARMC_' command).
Modulator preset 'D'
(ref. 'ARMD_' command).
Modulator preset 'V' assignment
(ref. 'ARMV_' command).
Modulator power offset
(ref. 'MPO_' command).
Modulator output power level
(ref. 'MOP_' command).
Scrambler enable
(ref. 'SE_' command).
Differential encoder enable
(ref. 'DENC_' command).
Modulator type
(ref. 'MT_' command).
Modulator encoder type
(ref. 'MET_' command).
Carrier only mode ON/OFF.
Demodulator IF
(ref. 'DF_' command).
p1 = n, where 'n' is '0' (off) or '1' (on).
p2 = nnn.nnnnnn, IF frequency in MHz.
p3 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p4 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p5 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p6 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p7 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p8 = nnnn_mmmm.mmm, code rate/data rate in kbit/s.
p9 = snn.n, modulator power offset in dB.
p10 = snn.n, transmitter output power level in dBm.
p11 = n, where 'n' is '0' (off) or '1' (on).
p12 = n, where 'n' is '0' (off) or '1' (on).
p13 = n, where 'n' is '0' (EFD), '1' (INTL), '3' (FDC), '4'
(CSC), or '6' (SDM51).
p14 = n, where 'n' is '0' ( SEQ), '1' (VIT).
p15 = n, where 'n' is '0' (off) or '1' (on).
p16 = nnn.nnnnnn, demodulator IF frequency in MHz.