beautypg.com

Comtech EF Data SNM-1002 User Manual

Page 166

background image

SNM-1002 LinkSync

 Modem

Revision 2

Remote Control Operation

MN/SNM1002.OM

A–40

Change
Status

Command:
Response:

>add/CS_x'cr''lf']

Where:

The 'x' character is defined as follows:

'@' = no change since last BCS_ and BCSF_
polls.

'A' = BCS_ response has changed since last
BCS_ poll.

'B' = BCSF_ response has changed since last
BCSF_ poll.

'C' = Both responses have changed since last
BCS_ and BCSF_ polls.

This command indicates that a change has or
has not occurred on either the BCS_ or the
BCSF_ response since the last BCS_ or BCSF_
poll.

Equipment
Type

Command:
Response:

>add/ET_tttttttt_xxx.yyy.zzz'cr''lf']

Where:
tttttttt = Equipment type.
xxx.yyy.zzz = Software version.

Monitor &
Control
Firmware
Information

Command:
Response:

>add/MCFI_'cr'
VER_xxx.yyy.zzz'cr'
FW/nnnnnn-ddr'cr'
mm/dd/yy'cr''lf']

Where:

xxx.yyy.zzz = Software version number (0.0.0 to
999.999.999).

nnnnnn = Firmware number (0 to 999999).

dd = Firmware dash number (0 to 99).

r = Firmware revision (-, or A to Z).

DATA ROM
Firmware
Information

Command:
Response:

>add/DFI_'cr'
FW/nnnnnn-ddr'cr'
mm/dd/yy'cr''lf']

Where:
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
r = Firmware revision (-, or A to Z).

Note: If Dash number is not used, '-dd' will be
reported.

Boot M&C
Firmware
Information

Command:
Response:

>add/BFI_'cr'
VER_xxx.yyy.zzz'cr'
FW/nnnnnn-ddr'cr'
mm/dd/yy'cr''lf']

Where:

xxx.yyy.zzz = Software version number (0.0.0 to
999.999.999).

nnnnnn = Firmware number (0 to 999999).

dd = Firmware dash number (0 to 99).

r = Firmware revision (-, or A to Z).