Comtech EF Data SNM-1002 - Manual (Page 34)

SNM-1002 LinkSync
 Modem
Revision 2
Installation MN/SNM1002.OM
2–4
2.2.1 Typical Single-Thread Cable Installation
Note: Cables may be procured from Comtech EF Data by contacting Comtech EF Data
Network Customer Support department for information.
1. Connect supplied Y-Cable (Figure 2-2) as follows:
a. Connect the supplied-cable base connector to the FASTCOM card.
b. Connect supplied-cable Port 1 connector to the Comtech EF Data
supplied EIA-422 cable from SNM-1001 Modem.
c. Cable Port 2 connector is not connected.
2. Connect 9-pin EIA-232 cable from Controller Server COM 1 port to SNM-1001
Remote port (J6).
a. If non-redundant SNM-1001, the following remote settings are required:
• EIA-232
• 19.2 Baud rate
• 8N1
3. Connect 9-pin EIA-232 cable from Controller Server COM 2 port to SNM-1002
Remote port (J6).
4. Connect 25-pin pre-programmed dongle (security key) to Controller Server
25-pin I/O port.
Figure 2-2. Typical Single-Thread Installation