BECKHOFF EP9214-0023 - Manual (Page 43)

Comissioning and Configuration
The release time depends on the set rated current.
CoE parameters for setting the current limiting characteristic
Fig. 44: CoE parameters for setting the current limiting characteristic
Meaning of the parameters
Index Name Meaning
0x80n0:02 Default State Us TRUE: in case of operation without fieldbus the load circuit Us of
channel n is automatically switched on
FALSE: in case of operation without fieldbus the load circuit Us of
channel n remains switched off
0x80n0:02 Default State Up TRUE: in case of operation without fieldbus the load circuit Up of
channel n is automatically switched on
FALSE: in case of operation without fieldbus the load circuit Up of
channel n remains switched off
0x80n0:11 Characteristic Release time depending on rated current
0x80n0:12 Nominal Current Us Specification of the rated current of Us in mA
0x80n0:13 Nominal Current Up Specification of the rated current of Up in mA
Switching load circuits on again after switch-off
This takes place either via the process data [ } 61] by EtherCAT or by the reset input [ } 26] directly on the
box.
4.4.4 Status LEDs and status bits
Below is a table showing the meaning of the status LEDs and status bits for the power outputs (EP9214 for
example):
EP9214-0023 and EP9224-0023 43 Version 2.0.0