ATEIS UAPg2 User Manual
Page 184
UAPG2 MANUAL
Version EN.24
184
The display/editor window displays an output to input graph, where the vertical axis corresponds to
the output signal level in dB, while the horizontal axis displays the input signal level in dB. The green
line reflects the currently set dynamic response graph of the compressor.
The small squares act as handles that can be dragged to the desired position and show the following
parameters:
o
red
Ratio x:1
o
blue
Threshold (dB)
o
yellow
Threshold range (dB)
Hard Clipping mode :
This is an example of a sinusoidal signal limited with and without Hard Clipping.
Without Hard Clipping
with Hard Clipping
Limiter Parameters
Parameter
Range
Comment
Graph...
Button
Opens the graphical display/editor window.
Threshold (dB)
60.0 to
20.0 dB
Sets the threshold level above which limiting begins.
Release time (ms)
10 to 1000 ms
Sets the time it takes to release gain reduction.
Bypass
On/Off
Bypasses the limiter's function.
Hard Clipping
On/Off
Enables/disables the “Hard clipping” mode.
Limiting
LED, lit red
Indicates limiting.
Gain reduction (dB)
0.0 to
-45.0 dB
Reflects the current amount of gain reduction.