API Audio 1608 Automation - Manual (Page 130)

To specify the number of channels to be controlled, use the following procedure:
1. Press the STATUS PAGE button to open the Status Page.
2. Press the MENU button to open the Main Menu.
3. Highlight “System Menu” using the Jog-Wheel and press the SEL (Select)
button. The System Menu will open.
4. Highlight “General Config” and press the SEL (Select) button. The General
Config dialog box will open.
5. Highlight the “Channels” pull-down menu and press the SEL (Select) button
to activate the menu.
6. Use the Jog-Wheel to highlight the needed number of channels (16, 32, or
48).
7. Press the SEL (Select) button to select the highlighted number of channels.
8. Set other general configuration parameters as needed.
9. Highlight the “OK” button and press the SEL (Select) button to apply the
selected number of channels and other general configuration parameters.
16.3.3.2 Timecode Source
The timecode source (LTC or MIDI TC) must be selected.
To select the timecode source, use the following procedure:
1. Press the STATUS PAGE button to open the Status Page.
2. Press the MENU button to open the Main Menu.
3. Highlight “System Menu” using the Jog-Wheel and press the SEL (Select)
button. The System Menu will open.
4. Highlight “General Config” and press the SEL (Select) button. The General
Config dialog box will open.
5. Highlight the “TC Source” pull-down menu and press the SEL (Select) button
to activate the menu.
6. Use the Jog-Wheel to highlight the needed timecode source (LTC or MIDI
TC).
7. Press the SEL (Select) button to select the highlighted timecode source.
8. Set other general configuration parameters as needed.
9. Highlight the “OK” button and press the SEL (Select) button to apply the
selected timecode source and other general configuration parameters.
16.3.3.3 Freewheel Frames
The number of freewheel frames needs to be set. This sets the tolerance applied
when chasing timecode.
To set the number of freewheel frames, use the following procedure:
1. Press the STATUS PAGE button to open the Status Page.
2. Press the MENU button to open the Main Menu.