Dataman 40Pro - Manual (Page 55)

DATAMAN-MEMPRO
55
Introduction
DATAMAN-MEMPRO is next member of new generation of Windows based DATAMAN
specialized programmers. Programmer is built to meet the demands of the development labs
and field engineers for a specialized memory programmer.
DATAMAN-MEMPRO can be upgraded to DATAMAN-40PRO using the XPro-Upgrade kit.
DATAMAN-MEMPRO is small, fast and powerful programmer for virtually all memory types -
EPROM, EEPROM, NVRAM, Flash EPROM and serial EEPROM - low voltage types
including. DATAMAN-MEMPRO isn't only programmer, but also static RAM tester.
DATAMAN-MEMPRO provides very fast programming due to high-speed FPGA driven
hardware and USB 2.0 full speed port.
DATAMAN-MEMPRO interfaces with the IBM PC Pentium compatible or higher, portable or
desktop personal computers through USB port, what is important for new, LPT-port-less
computers (notebooks for example).
DATAMAN-MEMPRO has 40 powerful TTL pindrivers provide H/L/pull_up/pull_down and
read capability for each pin of socket. Advanced pindrivers incorporate high-quality high-
speed circuitry to deliver signals without overshoot or ground bounce for all supported
devices. Pin drivers operate down to 1.8V so you'll be ready to program the full range of
today's advanced low-voltage devices.
The programmer performs device insertion test (wrong device position in socket) and
contact check (poor contact pin-to-socket) before it programs each device. These
capabilities, supported by signature-byte check help prevent chip damage due to operator
error.
When programming specification require, the (DATAMAN-MEMPRO) programmer performs
programming verification at the marginal level of supply voltage, which, obviously, improves
programming yield, and guarantees long data retention.
DATAMAN-MEMPRO is driven by an easy-to-use control program with pull-down menus,
hot keys and on-line help. Selecting of device is performed by its class, by manufacturer or
simply by typing a fragment of vendor name and/or part number.
Standard device-related commands (read, blank check, program, verify, erase) are
enhanced by some test functions (insertion test, signature-byte check), and some special
functions (autoincrement).
All known data formats are supported. Automatic file format detection and conversion during
load of file.
The rich-featured autoincrement function enables to assign individual serial numbers to
each programmed device - or simply increments a serial number, or the function enables to
read serial numbers or any programmed device identification signatures from a file.