Dataman 40Pro - Manual (Page 147)

PG4UWMC
147
Advanced options about Log file size limit are available too:
option Use Log file text truncating when file size limit is reached - when checked, the Log
file size limit is on. It means, that when Log file size reaches specified value, the part of
text included in Log file will be truncated. When the option is unchecked, the size of Log
file is unlimited, respectively is limited by free disk space only.
option Maximum Log file size specifies the maximum size of Log file in kB.
option Amount of truncated text specifies the percentage of Log file text, which will be
truncated after Maximum Log file size is reached. The higher value means more text will
be truncated (removed) from Log file.
Note: Lines start with '+' are shown in the log file, but not in the log at screen to keep better
overview of the on-screen log.
Common information:
Index of Programmer Site is integer number from 1 to 8 which defines unambiguously each
running Programmer Site.
Serial number of Programmer Site defines unambiguously the programmer or programmer
site used. Instance will search all programmers connected on USB Bus until it finds
programmer (site) with desired serial number. Programmers or Programmer Sites with
different serial numbers will be ignored. If the PG4UWMC does not find desired Programmer
Site, the Programmer Site will be set to Demo mode with status set to "Not found".
On one computer, 8 Programmer Sites can be run at the same time.
Job Report settings are used to set mode of using Job Report.
Job Report represents the summary description of operation recently made on device. Job is
associated with project file and it means the operation starting with Load project until loading
of new project or closing program PG4UWMC.
Job Report contains following information:
project name
project date
Protected mode status
PG4UWMC software version
programmer type and serial number
start time of executing the Job (it means time when Load project operation was
performed)
end time of executing the Job (time of creating the Job Report)
device name
device type
checksum
device operation options
serialization information
statistics information
Job Report is generated in following cases:
user command Load project is selected
closing or disconnecting programmer sites is selected
closing the PG4UWMC
device Count down counter reaches 0 (finished status)
manually by user, when menu "File | Job Report" is used