Dataman 40Pro - Manual (Page 38)

38
Multiprogramming by DATAMAN-48PRO2 /
DATAMAN-48PRO2C
During installation of PG4UW at Select Additional Tasks window you check, if is allowed
install DATAMAN-48PRO2 / DATAMAN-48PRO2C multiprogramming control support.
For start of DATAMAN-48PRO2 / DATAMAN-48PRO2C multiprogramming is necessary run
special control program pg4uwmc.exe. At this program user assign DATAMAN-48PRO2 /
DATAMAN-48PRO2C to control programs, may load projects for all DATAMAN-48PRO2 /
DATAMAN-48PRO2C and run PG4UW for every connected and assigned
DATAMAN-48PRO2 / DATAMAN-48PRO2C.
Selftest
If you feel that your programmer does not react according to your expectation, please run the
programmer (ISP connector) selftest using Diagnostic POD (Diagnostic POD for ISP
connectors #2), enclosed with the standard delivery package.
Selftest of programmer
Insert 48 pins diagnostic POD - type I into ZIF socket of the programmer. 48 pins
diagnostic POD - type I must be inserted as 48 pins device.
Run selftest of programmer in PG4UW (Programmer / Selftest plus).
Selftest of ISP connector
Insert Diagnostic POD for ISP connectors #2 into ZIF socket of the programmer.
Diagnostic POD for ISP connectors #2 must be inserted as 48 pins device.
Interconnect 20 pins connector of Diagnostic POD for ISP connectors #2 with an ISP
connector of the programmer with an ISP cable, included in delivery programmer
package. Be sure that pins are interconnected properly (i.e. 1-1, 2-2, ..., 20-20).
Run selftest of ISP connector in PG4UW (Programmer / Selftest ISP connector…).