Dataman 40Pro - Manual (Page 145)

PG4UWMC
145
column Project file contains edit lines Project: #1, Project: #2, ...Project: #4 for setting
individual projects to be loaded after running each PG4UW. Project file names can be
entered manually or by dialog Select project file, which can be opened for each Site by
clicking on button "..." placed on the right side of each project edit line. If the project name
edit line is blank, the automatic project load will not be performed.
Checkbox Use one common project for all Sites
Checkbox Use one common project for all Sites is placed under the Sites numbers and
Projects table.
When there is requirement to program the same device types with the same data, the
checkbox should be checked.
If the checkbox is checked, the project file for Site #1 will be used also for all other
Programmer Sites. In this mode all Sites are using the same shared buffer of project data
and program the same device type.
If the checkbox is not checked, each Site will use its own project file defined by name in
table of Sites in column Project file. In this mode each Site is using its own buffer of
project data, which allows to program different data to different types of devices at the
same time in each Site.
Auto-connect sites after PG4UWMC start. Presuming the remembered sites are connected
and ready.
Force YES for gang multiprogramming mode
Standard mode of multiprogramming operation on our multiprogrammers is concurrent
multiprogramming mode, when each programming site works independently and operator
can re-load programmed device while other programming sites are running. In gang
multiprogramming mode predefined operation starts on all programming sites at a time
by pressing any YES! button.
Notes:
works for all active (present and enabled) sites,
start is blocked while any site is busy,
in this mode Automatic YES! is disabled.
Panel Log file settings are used to set mode of using Log file report