Dataman 40Pro - Manual (Page 142)

142
Program PG4UWMC is used for fully parallel concurrent device multiprogramming on more
programmers or on one multiprogramming capable programmer connected to USB ports to
the same computer.
PG4UWMC is focused to the easy monitoring of high-volume production operations.
Operator-friendly user interface of PG4UWMC combines many powerful functions with ease
of use and provides overview of all important activities and operation results without burden
of operator with non-important details.
PG4UWMC is using a project file to control the multiprogramming system. Project file
contains user data, chip programming setup information, chip configuration data, auto
programming command sequence, etc. Therefore the operator error is minimized, because
the project file is normally created and proofed by engineering and then given to the operator.
The optional protected mode can be set for project file to avoid unwanted changes of the
project file.
Each chip may be programmed with different data such as serial number, configuration and
calibration information.
Program PG4UWMC consists of following main windows:
main window
settings dialog window
"Search for Programmers" dialog window
For more details about multiprogramming and how to use PG4UWMC, please refer to user
manual for any of our USB interfaced concurrent multiprogramming system (programmer).
The basic description of the main parts of PG4UWMC
PG4UWMC main window