Software, Command line parameters – Dataman 40Pro User Manual
Page 161
Common notes
161
Biannual maintenance
Perform the “Selftest plus” for every programmer or programming module.
Annual maintenance
Gently clean the surface of the programmer with isopropyl alcohol or technical alcohol on a
soft cloth. The LCD clean with a soft cloth moisten in water only. Isopropyl alcohol may
damage surface of the LCD.
Perform the calibration test if the programmer supports this feature.
Warning:
The ZIF socket of the programmer and the socket converters are considered as
consumables. The life cycle of the ZIF socket of the programmer' is about 25.000 mechanical
cycles. The life cycle of ZIF sockets of the socket converters is in generally from 5.000 to
10.000 mechanical cycles, even if the life cycle of some specialized BGA ZIF sockets can be
about 500.000 mechanical cycles. Programmed devices, environment and ZIF maintenance
have direct influence to actual electrical lifetime of ZIF socket (it means that ZIF socket does
not cause programming failures yet). Keep fingers away from contacts of ZIF socket, because
contacts of the ZIF socket fouled by smear and grime from fingers may cause the
programming failures. Change the ZIF socket or the socket converter if you noticed increased
number of programming failures.
The warranty does not apply to the ZIF sockets that are wear or grimy and which cause large
amount of failures during working with programmer.
Software
PG4UW is common control program for some DATAMAN programmers. Thus, during work
with him it is possible to find some items, those refer not to current selected programmer.
Command line parameters
We recommend using special utility pg4uwcmd.exe to make command line parameter
control of PG4UW. For backward compatibility there is possible to use some command line
parameters also directly with pg4uw.exe, but better way is to use pg4uwcmd.exe, which has
support of more command line commands and also it has capability to return ExitCode (or
ErrorLevel) value indicating success or error result of executing command line parameters.
For more information about using pg4uwcmd.exe command line controller for PG4UW,
please take a look at Remote command line control of PG4UW.
Command line parameters which can be used directly with pg4uw.exe
/Prj:
forces project load when program is starting or even if program is
already running,
and name
/Loadfile:
running,
loaded, file format is detected automatically
/Saveproject:
the command is used to save currently selected device type,
buffer contents and configuration to project file. Command
/Saveproject:... is equivalent to user selected command Save
project in PG4UW control program.