Device / verify, Device / program, Device / erase – Dataman 40Pro User Manual
Page 113: Device / test
PG4UW
113
configuration areas can be viewed or edited in dialogs available by menu View / Edit buffer
and menu Device / Device options / Special options (Alt+S).
The control program reports a finish of Read action by writing a message to INFO window.
The menu command Device / Device options / Operation options allows to set another
working area as the standard. Setting an option Verify data after reading in this menu
command means a higher reliability for device reading.
Device / Verify
This command compares content of the whole device including its available special areas
with data in buffer. The control program reports a result of verify operation to Info window and
Log window.
The menu command Device / Device options / Operation options of PG4UW allows to
customize available operation options.
Settings in dialog General options (menu Options / General options) of PG4UW in tab
Errors allows to control, how to write the found errors to user specified report file. Also first
45 found errors are written to Log window.
Note:
Verify operation compares content of the whole chip with the data in the software,
therefore it might happen - in case of incomplete programmed chip - the verification after
programming shows none error, but solo verify operation does not pass.
Verify operation can report errors also in case of protected devices that have active read
protection of data.
Device / Program
This command executes device programming. The control program reports a result of this
action by messages in INFO window and LOG.
The menu command Device / Device options / Operation options of PG4UW allows to
customize areas to be programmed, and set other operation options.
Device / Erase
This command executes device erase. The control program reports a result of this action by
messages in INFO window and LOG.
The menu command Device / Device options / Operation options of PG4UW allows to
customize available operation options.
After Erase, if device (chip) doesn't support erase verify command, the blank check operation
takes place to verify successfulness of Erase operation.
Device / Test
This command executes a test of device selected from list of supported devices (for example
static RAM) on programmers, which support this test.