Dataman 40Pro - Manual (Page 18)

18
DATAMAN-448PRO2 performs on each programming module device insertion test (wrong
or backward position) and contact check (poor contact pin-to-socket) before it programs
each device. These capabilities, supported by overcurrent protection and signature-byte
check help prevent chip damage due to operator error.
DATAMAN-448PRO2 have the selftest capability, which allows run diagnostic part of
software to thoroughly check the health of the each programming module.
DATAMAN-448PRO2 have a built-in protection circuits for eliminate damage of programmer
and/or programmed device due to environment or operator failure. All ZIF socket pins of
DATAMAN-448PRO2 programmer are protected against ESD up to 15kV.
When programming specification require, the (DATAMAN-448PRO2) programmer performs
programming verification at the marginal level of supply voltage, which, obviously, improves
programming yield, and guarantees long data retention.
Various socket converters are available to handle device in PLCC, SOIC, PSOP, SSOP,
TSOP, TSSOP, TQFP, QFN (MLF), SDIP, BGA and other packages.
DATAMAN-448PRO2 programmer is driven by an easy-to-use control program with pull-
down menu, hot keys and on-line help. Selecting of device is performed by its class, by
manufacturer or simply by typing a fragment of vendor name and/or part number.
Standard device-related commands (read, blank check, program, verify, erase) are boosted
by some test functions (insertion test, signature-byte check), and some special functions
(autoincrement, production mode - start immediately after insertion of chip into socket).
All known data formats are supported. Automatic file format detection and conversion during
load of file.
The rich-featured autoincrement function enables to assign individual serial numbers to
each programmed device - or simply increments a serial number, or the function enables to
read serial numbers or any programmed device identification signatures from a file.
The software also provides a lot of information about programmed device. As a special, the
drawings of all available packages, explanation of chip labeling (the meaning of prefixes
and suffixes at the chips) for each supported chip are provided.
The software provide full information for ISP implementation: Description of ISP connector
pins for currently selected chip, recommended target design around in-circuit programmed
chip and other necessary information.
The remote control feature allows PG4UW software to be flow controlled by other
application – either using .BAT file commands or using DLL file. For DATAMAN-448PRO2 is
remote control limited for ISP programming only.
Jam files of JEDEC standard JESD-71 are interpreted by Jam Player. Jam files are
generated by design software which is provided by manufacturer of respective programmable
device. Chips are programmed in ZIF or through ISP connector (IEEE 1149.1 Joint Test
Action Group (JTAG) interface).