2 setup – CIRCUTOR CVMk2 Series User Manual

Page 83

CVM

CONFIGURA

TION

To modify the current values, press

EDIT

(F4). The cursor will be positioned in the first line of

parameters. Use the up-down arrow buttons to move the cursor to the desired parameter and
press

SET

to enter edit mode.

Use the left/right arrow buttons to navigate from one digit to another and the up/down arrow

buttons to increase/decrease the value of the digit where the cursor is currently positioned.

Parameters that can be viewed on this screen follow:

Mod. name

: Current name or name to be given to the measurement module. When the

parameters of this module are displayed, this name is also displayed in the

upper right hand corner of the screen.

module s/n

: The module serial number. This number is only informative, not editable.

Per. num.

: By default, this is 1 when there is only one measurement module connected.

This number is automatically generated. It is only informative and cannot be

edited. It also indicates the order in which the modules will appear on the

list

display screen discussed in Section 5.3.1.

If more than one module is connected, other modules can be modified by pressing the

button (F1). This advances the user to the next module in the list, where names can be edited

without exiting the edit screen.

5.3.2 SETUP

To change the modules' configuration parameters, choose the

system

option on

. In the

system

menu, access the

modules

drop down menu and select the

setup

option. Then, confirm

with the

set

button.