CIRCUTOR CVMk2 Series - Manual (Page 73)

73
CVM k2
CONFIGURA
TION
4.7.7 - PROFIBUS COMMUNICATIONS CARD
Read Section 4.7.0., Inserting
Expansion Cards.
4.7.7.1. Profibus card configuration
This card has no paramenters to configure. Only the peripheral number (Slave ID) explained
in chapter 4.7.7.3
Going into configuration menu only will appear: CARD. OK or CARD NOK .
To access the configuration of the card of profibus protocol, enter the configuration menu ( menu
---> setup. ). in the EXP. CARD menu, select the position where the card is inserted. Press SET to
enter in the card menu.
4.7.7.2. Card parameters
To visualize the parameters that CVMk2 shows refering to the profibus communications card,
you have to go to the cards menu:
MENU --> EXP. CARD --> CARD X*.
(*) Value 1, 2 or 3, depending on the card position.