Configuration, 1 measuring – CIRCUTOR CVMk2 Series User Manual

Page 29

CVM

CONFIGURA

TION

4.1 MEASURING

Measurement, communication and expansion card parameters (if available) can be modified

from the configuration menu.
To access the configuration inside the

, select

Setup

and confirm with the

set

key.

The menu on the top of the screen will appear as seen in the following figure.

In the

MEASURE

menu, the list of voltage and current transformers can be accessed. To modify

the transformer configuration parameters, press the

EDIT

button (F4).

4. CONFIGURATION

Position the cursor in the first line of parameters (primary voltage). Use the up-down arrow
buttons to move the cursor to the desired parameter. Press

SET

to enter the numeric value to

be modified. The cursor will be positioned over the first digit, corresponding to the largest value.

Use the left/right arrow buttons to navigate from one digit to another and the up/down arrow

buttons to increase/decrease the value of the digit.

The analyzer does not store programming changes that are made until
programming is complete. These changes are confirmed by pressing

SET

and

after the

button. If the system is reset before said programming is complete or

if the user exits the menu using the

esc

button, the configuration settings will not

be stored in memory. To access to the configuration menu, refer to Chapter 4.