CIRCUTOR CVMk2 Series - Manual (Page 69)

69
CVM k2
CONFIGURA
TION
The parameters that we can modify are:
VAR. CODE : That value in the electrical variable code that we want to assign to the (see
variable code table). Are not allowed energy codes.
val - 5
m
a : Select the value that corresponds to -5 mA in the oputput.
val +5
m
a: Select the value that corresponds to +5 mA in the oputput.
In the edition screen appears the keys:
ESC : Used to go back without saving changes.
OK : Used to confirm / save changes and go out of editor mode.
The function keys are:
NEXT : It increases the output number until number 4 ( A/D OUT 04 ). If we press NEXT again,
returns to output number 1 (A/D OUT 01 ).
DIG : Pressing that key we can go to alarm screens configuration (Section 4.7.6.3).
EDIT : Press to edit the parameters of the analog outputs. Move with the arrows to select the
parameter to modify and press SET to enter the value.
4.7.6.3. Alarm configuration
4.7.6.2. ± 5 mA analog outputs configuration
The configuration screen is as follows
When cards configuration is accessed, the following menu will appear for ALARM 01