StorCase Technology CSI-to-SCSI Single & Dual RAID - Manual (Page 51)

38 Configuration
StorCase Technology, Inc. Dual RAID Module User's Guide - Rev. A03
Verifying an Array
This function allows the user to verify data on a specified array (RAID 3, RAID 4, RAID 5, RAID
50, and Mirrored arrays only).
• RAID 3, RAID 4, RAID 5, and RAID 50 - Verifies all parity blocks in the selected array
and corrects any bad parity.
• Mirrored - Compares the primary and secondary drives. If a mismatch occurs, the
primary is copied to the secondary.
Verify an array whenever a problem is suspected.
To verify an array:
1. Select Array Menu from the System Menu and press Enter.
The Select Array screen should now display, along with a list of existing arrays (Figure
19).
2. Select the array to verify and press Enter.
The Array Menu should now display (Figure 20).
3. Select Verify Function and press Enter.
The Verify Menu should now display (Figure 27).
Figure 27: Verify Menu Screen
4. Select Start Verify and press Enter.