StorCase Technology CSI-to-SCSI Single & Dual RAID - Manual (Page 29)

16 Configuration
StorCase Technology, Inc. Dual RAID Module User's Guide - Rev. A03
Serial Port Set-Up
To access the Administrator Utility via the UI Module RS-232 serial port, the user must first
configure the Serial Port Set-Up in the UI Module (see below).
Refer to the InfoStation User's Guide (specifically, sections "InfoStation User Interface" and
"Serial Port Set-Up") for further information.
1. Press ENTER at the Default Display so that
display = Status.
2. Press DOWN until display = Setup.
3. Press ENTER so that display = Alarm.
4. Press DOWN until display = Ser.Port
5. Press ENTER so that display = S-Portx .
This is the current serial port set-up.
6. Press UP or DOWN to change the serial port
option.
7. Press ENTER to accept the change.