StorCase Technology CSI-to-SCSI Single & Dual RAID - Manual (Page 116)

Dual RAID Module User's Guide - Rev. A03 StorCase Technology, Inc.
Configuration 103
Table 8: Alarm Thresholds and Procedures
To enable/disable the alarm:
1. Select Configuration Menu from the System Menu and press Enter.
The Configuration Menu should now display (Figure 31).
2. Select Alarm Mute and press Enter.
The Alarm Mute screen will display (Figure 65).
The current setting is marked with an * next to it.
Changing the Alarm Mute Setting
This function allows the user to enable/disable the audible alarm. Changing the mute setting
allows the user to turn OFF the alarm (the alarm should be turned back ON once the problem
is resolved).
Alarm conditions will trigger event messages that display in the Disk Array Administrator Utility
and in the event log (refer to section "Displaying the Event Log" for further information).
Alarm Threshold Procedures
IFSII_DR16
VCC Voltage
Shutdown: 5V -6.5% and +10%
12V Voltage
Shutdown: 12V -10% and +10%
Onboard Temperature
Warning: 0 C - 5 C and
45 C - 50 C
Shutdown: < 0 C
> 50 C
Check the Disk Array Administrator Utility for more details (refer to section
“Accessing the Disk Array Administrator Utility”).
CPU Temperature
Warning: 0 C - 5 C and
65 C - 70 C
Shutdown: < 0 C
> 70 C
Check the ambient temperature and lower the threshold (if necessary).
Ambient temperature should be less than 45 C.
Check the Disk Array Administrator Utility for more details (refer to section
“Accessing the Disk Array Administrator Utility”).
Check the Disk Array Administrator Utility to for more details (refer to section
“Accessing the Disk Array Administrator Utility”).
Check the Disk Array Administrator Utility for more details (refer to
section “Accessing the Disk Array Administrator Utility”).
For shutdown events, turn OFF power to the controller and send it in for
servicing