StorCase Technology CSI-to-SCSI Single & Dual RAID User Manual

Page 100

Dual RAID Module User's Guide - Rev. A03

StorCase Technology, Inc.

Configuration

Host Channel

Setting

Available

Modes

Description

Controller LUN

All

The controller has just one LUN that the user can change when

configuring the host channels. The user only needs to assign

a controller LUN if using the Configuration Application Program

Interface (CAPI) to configure the controller over a host channel

via SCSI protocol extensions.

If not using CAPI, the user can set the controller LUN to NONE.

If using CAPI, the user can set the controller LUN from 0-63.

Two options for setting the LUN:

NONE: Use this setting if not using CAPI to configure the con-

troller (change takes effect immediately unless the controller

LUN is currently in use).

Any number between 0-63: Select a specific number if the con-

troller LUN is to remain the same during reboot.

Refer to section

Understanding

LUNs and Viewing

LUN Information

for further informa-

tion.

IFS_83

Table 6: Host Channel Settings (cont'd)

To configure the host channels:

Select Configuration Menu from the System Menu and press Enter.
The Configuration Menu should now display (Figure 31).

Select Host Configuration and press Enter.
The Channel screen should now display.

Select the desired channel to configure and press Enter.
The current setting is marked with an * next to it.
Refer to Table 6 for further information about each setting.

Select the desired setting from each screen and Press Enter.
The system will now confirm the settings.

Select Yes and press Enter.