Kipp&Zonen 2AP Sun Tracker User Manual
Page 81
OPERATION
80
Table 10:
CMD Window Elements.
Port
- The serial port that connects the 2AP to the computer.
Connect
- Connect to the 2AP on the specified COM port.
Disconnect
- Disconnect from the 2AP.
2AP Status
- The status of the software.
Serial Number
- The serial number of the 2AP obtained by the SE command.
Password
- The password of the 2AP. This is unknown if the password is not 0
or 65535 and the PW command has not been sent.
Command
- Enter the two-letter command to be sent to the 2AP here.
Send
- Send the command entered to the 2AP.
Reply
- Communication sent to and received from the 2AP.
Write Config to 2AP
- Choose an ini file and write the configuration from that ini file to the
2AP.
Read Config from 2AP
- Save the configuration from the 2AP to an ini file. Use this if you
want to create a new Win2AP.ini file.
Create Script/
Close Script
- Pressing this records all commands sent to the 2AP in a text file.
To end the script press the same button again (the button will now
be called “Close Script”).
Edit Script
- Opens a previously recorded script in Notepad so it can be edited.
Run Script
- Executes all the commands in the chosen script.
Find Password
- Searches through all possible passwords until the 2AP’s password
is found. The password is then changed to 65535.
Auto download 2AP log
- Automatically downloads the 2AP log when checked.
Downloading Log
- Flashes when the log is being downloaded.
File | Download 2AP Log
- Downloads the 2AP Log (using the LO command).
File | View 2AP Log /
View log
- View the downloaded 2AP event log.
File | View Event Log
- View the Win2AP software event log.