Kipp&Zonen 2AP Sun Tracker - Manual (Page 106)

APPENDIX I
105
APPENDIX I
Addendum to the 2AP Instruction Manual
In contrast to the drawings in this manual the EMI filter in the 2AP Gear Drive has been relocated
from the safety cover of the power board to a position closer to the incoming power cable.
This change is with respect to 2AP GD units with the serial number 0212 or higher.
See the figure below, which illustrates the new position of the EMI filter.
Power board 115/230 VAC
(shown without safety shield)
Fuse F2 (optional heaters)
Fuse F1 (main power)
EMI filter
Figure: Relocation of the 2AP Gear Drive EMI Filter.