Kipp&Zonen 2AP Sun Tracker - Manual (Page 21)

INSTALLATION AND SETUP
20
Figure 4.2: Overview of the various pages in Win2AP.
Suntracker Setup Procedure
1. Mounting Suntracker
2. Power Up Procedure
3. Levelling Gear Drive
4. Rear Mounting Plate Assembly
5. Large Side Mounting Plate Assembly
6. Pointing and Shading Ball Assembly
7. Mounting Sun Sensor
8. Pyrheliometer Installation
9. Pyranometer Installation
10. Verification of Levelling
11. Cold Weather Cover Installation
12. Setting Time and Location
13. Conclusion
Sighting Adjustment
1. Sighting Adjustment without Sun Sensor
Sighting Adjustment
1. Azimuth orientation
2. Sun Sensor Alignment
3. Tilt Correction
4. Active Time Correction
Run Suntracker
1. Suntracker Monitor Window
Positioner Setup Procedure
1. 2AP Azimuth Orientation
2. Mounting the 2AP as Positioner
3. Power Up Procedure
4. Levelling Gear Drive
5. Large Side Mounting Plate Assembly
6. Adapting 2AP Zenith Range
7. Configuring the 2AP for Positioner Purpose
8. Attaching Instruments to the Side Plates
9. Verification of Levelling
10. Cold Weather Cover
11. Conclusion
Run Positioner
1. Positioner Monitor Window
Post Delivery Check
1. Accessory List
2. Power Use Verification
Setup Preparation
1. Getting Acquainted with the 2AP
2. Communication Test
3. Password Activation / Deactivation
4. Alternate Montage of the 2AP
5. 360º Limit Option (Gear Drive only)
6. Minimum Setup Requisites
Software Setup Procedure
1. Setup Shortcut
Maintenance
1. Maintenance
Troubleshooting
1. Troubleshooting
2. Change Password
3. Cold Start
4. Contact Manufacturer