Kipp&Zonen 2AP Sun Tracker - Manual (Page 20)

INSTALLATION AND SETUP
19
The Win2AP software is compatible with older 2AP’s that run with DOS software. To upgrade the
software continue with:
• Connect the 2AP communication cable to the PC.
• Double click on Win2AP.exe with the Kipp & Zonen logo to open the software.
• Press the “Troubleshooting” button in the Main Menu.
• Press the “Run CMD” button on the bottom of page 1.
• Select the correct com port.
• To communicate with the 2AP, press the “Connect” button.
• Press the “Read Config From 2AP” button.
• Enter a file name (e.g. Win2AP.ini) to save the configuration file on your PC.
• If the Password reads 65535 it has been set to a default integer. Press the “Disconnect”
button in the CMD window and follow the steps on page 2 of the Troubleshooting Procedure
to reconfigure a Password. You will find the original 2AP password in the baseline.ini file of
the DOS software.
4.1.3 Win2AP Overview
Double clicking on Win2AP.exe with the Kipp & Zonen logo will open the software. The buttons in
the Main Menu of the Win2AP software provide access to the various pages for 2AP instalment, see
figure 4.1. An overview of the various pages behind the buttons in the Main Menu is given in figure
4.2.
Figure 4.1: Win2AP Main Menu.