Dialogic M7324 - Manual (Page 111)

4. PBX Systems
Lines (for each trunk going directly to the board)
Trunk/Line Data:
Trunk Type: Loop (see below for DID programming)
Line Type: Pool A
Dial Mode: Tone
Prime Set: None – can be set as subscriber if required
Auto Privacy: Y
Trunk Mode: Super
Answer Mode: Manual
Line @ CO: N
Aux Ringer: N
Full Auto Hold: N
Loss Package: Medium CO
Name: Set to fit needs
Restrictions: Default
Telco Features: Default
Services – Default
System Speed Dial – Default
Passwords – Default
Time & Date – Set current
System Programming – Default for all settings except Access Codes
Access Codes:
Line Pool Codes:
Pool A: 9 – or whatever code will be used to dial out
Telco Features - Default
Software Keys - Default
Hardware - Default
Maintenance - Default
NOTES: 1. Options not listed in this section can be set as needed for the
subscribers.
2. If the d42_getcallidex( ) function is being implemented, then the
first port of the Dialogic ® PBX Integration Board must be set as
the prime set for a line in order to differentiate between an
111