Hanna Instruments HI 901 - Manual (Page 89)

6-5
TITRATION MODE
- allows you to save the graph as a bitmap file. Available only when the titration is
finished (after end point detection).
6.2 Titration Stop
The titration can be finished in one of the modes described below:
• Titration Completed. The titration was successfully terminated (with end point
successfully detected). This is the only mode with valid final result values.
• Manually Terminated. The current titration was manually terminated before end
point detection was achieved.
• Limits Exceeded. The preset maximum titrant volume was delivered without
reaching the end point. The titration is stopped with an error message.
• Critical Error. A critical error occurred and the titration was stopped. These
errors are normally related to the dosing system. The titration is stopped with a
specific error message.
• Potential Out of Range. The measured values from the input sensor are outside
the preset range (potential range). The titration is stopped with an error message.