Setup – Hanna Instruments HI 901 User Manual
Page 15
2-9
SETUP
HI 902 only:
Follow the previous steps (2.3.4.3) to connect and attach the second pump.
2.3.4.4 Attaching Burette Blank Support (HI 901 only)
The burette blank support installation procedure is as follows:
Insert burette blank support (4) in the dedicated bay - on the right side (see the
previous picture). Lower the burette blank support until it reaches the lowest position,
then push it toward the front of the titrator chassis (1) until it is firmly latched.
Secure the burette blank support with the locking screw (5).
2.3.4.5 Attaching Burette
Make sure that the mark from the valve actuating cap and from the burette body are aligned
as shown in the figure below.
Take care to have a correct coupling between the pump plunger (2) and the syringe piston
(1) and also when sliding the burette onto its support, consider the alignment between the
valve actuating cap and the valve positioning wheel, as shown in the figure below.