beautypg.com

EXFO IQS-2400 WDM Laser Source for IQS-500/600 User Manual

Page 65

background image

Monitoring WDM Laser Source Modules

WDM Laser Source

59

Using QuickTools

To control a specific source with QuickTools:
1.
Ensure that the source monitor window is selected.

2. Select the appropriate control mode. For a full explanation on control

modes, see Selecting a Control Mode on page 21.

3. From the Wavelength section, adjust the wavelength as follows:

3a. If the control mode is Normal or Dither Modulation, select

between frequency (THz) and wavelength (nm).

3b. Adjust the value and confirm your settings.

4. From the Power section, adjust the power as follows:

4a. If the control mode is Normal or Dither Modulation, select the unit

in which you want the values to be expressed: mW or dBm.

4b. Adjust the value and confirm your settings.

5. Unlock the source and turn it on. For more information, see Activating

and Deactivating the Source on page 41.

Note: Preset values are not available from the QuickTools utility.

To close QuickTools:

³

Click the Close button located at the top of the window.

OR

³

Click outside the QuickTools window.

To close a monitor window:
Click the button on the upper left of the monitor window and select
Remove Monitor.

OR

Click the Close All button at the bottom of the window.