EXFO IQS-2400 WDM Laser Source for IQS-500/600 - Manual (Page 38)

Setting Up the WDM Laser Source
32 IQS-2400
Configuring Power or Delta Current
To configure the source delta current in High Wavelength
Stability or On/Off Modulation mode:
Set the delta current using one of the following methods:
³
Slider or navigation buttons
³
Up/down arrows to select the predefined parameters from the
Presets list and
to confirm the selection. For more information,
see Managing Predefined Parameters (Presets) on page 34.
The source takes a few seconds to adjust to the selected values, a message
will be displayed on the left, just above the current source mode.
Delta current
control
Presets list