EXFO IQS-2400 WDM Laser Source for IQS-500/600 - Manual (Page 158)

SCPI Command Reference
152 IQS-2400
Product-Specific Commands—Description
:SOURce[1..n]:PULM:STATe
Description This command is used to set the modulation to
on or off.
At *RST, modulation is off.
Syntax :SOURce[1..n]:PULM:STATe
State>
Parameter(s) ModulationState:
The program data syntax for
is defined as a
element. The special forms
ON and OFF are accepted on input for increased
readability. ON corresponds to 1 and OFF
corresponds to 0.
The parameter is the
desired modulation state.
0 or OFF, deactivates the modulation.
1 or ON, activates the modulation.
Example(s) SOUR:PULM:STAT ON
Notes This command is meant to be used in
conjunction with
SOURce[1..n]:WAVelength:MODE.
When the modulation is on and the resolution
mode is normal, then the dither modulation is
selected. If the resolution mode is high
resolution, then On/Off modulation is selected.
See Also SOURce[1..n]:PULM:SOURce?
SOURce[1..n]:PULM:SOURce
SOURce[1..n]:PULM:STATe?
SOURce[1..n]:WAVelength:MODE