Dialogic SS7G2X - Manual (Page 82)

82
Chapter 6 Command Definitions
6.8.3 MMLOS – MML Log Off Set
Synopsis
This command sets the current log-on time-out ( TLO ) and timeout warning ( TLOW ) parameters. If TLOW is
set to zero, the automatic time-out is disabled. If port ( PORT ) is omitted, the command applies to all ports.
Syntax
MMLOS:{[ TLO =,][ TLOW =,]}[ PORT =,];
Prerequisites
None
Attributes
CONFIG
Examples
MMLOS: TLO =35;
MMLOS: TLOW =19;
6.8.4 MMPTC – MML Port Change
Synopsis
This command sets the data input/output parameters for serial and telnet data ports.
Note: Only serial port 2 (COM2) is accessible by the user.
Syntax
MMPTC: PORT =,{[BAUD=,][ DBITS =,][ PARITY =,][ SBITS =,][ LINES =,][ PTMODE =,]};
Prerequisites
•
No user must be logged on to the port affected.
•
For the telnet ports, only the LINES parameter can be changed.
Attributes
CONFIG
Examples
MMPTC: PORT =2,BAUD=300;
MMPTC: PORT =2, SBITS =2;