Dialogic SS7G2X - Manual (Page 29)

29
Dialogic ® SS7G2x Signaling Server SGW Mode User Manual Issue 4
4.14.4 License Update by FTP
The user is also able to install licenses from system start.
Note: Installation of licenses from system start is not normal operating procedure and should only be
used if the user is unable to install licenses via MML.
The procedure to install licenses from system start is as follows:
1. Rename the purchased license file to sgw.lic.
2. Establish an FTP session (see
Section 4.9, “FTP Access” on page 23 ).
3. Set the FTP transfer mode to “ASCII”, since the license file is a text file.
4. Transfer the software license to the Signaling Gateway by typing the command “put sgw.lic sgw.lic”.
Note: The Signaling Gateway uses a case-sensitive file system. Therefore, it is necessary to specify
sgw.lic
in lowercase.
5. Terminate the FTP session by entering “quit” or “bye”.
6. Establish an MML session and restart the unit by typing the
MNRSI command.
The machine then boots and completes the upgrade. Once the upgrade is complete, the machine is
accessible via MML.
7. Check the licenses using the CNSYP command.