Dialogic SS7G2X - Manual (Page 49)

49
Dialogic ® SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.5.1 CNBOI – Configuration Board Initiate
Synopsis
This command defines a new board on the system.
The user should specify the board position ( BPOS ) within the unit, the physical type of the board ( BRDTYPE )
and the signaling type ( SIGTYPE ), which identifies the software that will run on the board.
See Section 7.1.2, “Boards and PCMs” on page 136 for a more detailed description of board configuration.
Syntax
CNBOI: BPOS =, BRDTYPE =, SIGTYPE =;
Prerequisites
•
No board has already been defined for the specified board position.
•
A board must physically exist for the board position and be licensed for the signaling gateway.
•
A board type of SS7HDP must have a signaling type of SS7.
Attributes
CONFIG
Examples
CNBOI: BPOS =1, BRDTYPE =SPCI4-4-4, SIGTYPE =SS7;
CNBOI: BPOS =1, BRDTYPE =SPCI2S-4-2, SIGTYPE =SS7;
CNBOI: BPOS =3, BRDTYPE =SS7HDP-64-4, SIGTYPE =SS7;
6.5.2 CNBOE – Configuration Board End
Synopsis
This command deassigns a board from a board position.
Syntax
CNBOE: BPOS =;
Prerequisites
•
A board has been defined for the specified board position.
•
No signaling processor on the board has been allocated to a signaling link.
•
No PCM on the board is configured.
•
The board has been blocked.
Attributes
CONFIG
Examples
CNBOE: BPOS =3;